Datasheet

DocID018576 Rev 5 47/103
STM8S003F3 STM8S003K3 Electrical characteristics
87
9.1.6 Pin input voltage
The input voltage measurement on a pin of the device is described in Figure 8.
Figure 8. Pin input voltage
9.2 Absolute maximum ratings
Stresses above those listed as ‘absolute maximum ratings’ may cause permanent damage
to the device. This is a stress rating only and functional operation of the device under these
conditions is not implied. Exposure to maximum rating conditions for extended periods may
affect device reliability.
V
IN
STM8 pin
Table 16. Voltage characteristics
Symbol Ratings Min Max Unit
V
DDx
- V
SS
Supply voltage (including V
DDA and
V
DDIO
)
(1)
1. All power (V
DD
, V
DDIO
, V
DDA
) and ground (V
SS
, V
SSIO
, V
SSA
) pins must always be connected to the
external power supply
-0.3 6.5
V
V
IN
Input voltage on true open drain pins (PE1, PE2)
(2)
2. I
INJ(PIN)
must never be exceeded. This is implicitly insured if V
IN
maximum is respected. If V
IN
maximum
cannot be respected, the injection current must be limited externally to the I
INJ(PIN)
value. A positive
injection is induced by V
IN
>V
DD
while a negative injection is induced by V
IN
<V
SS
. For true open-drain pads,
there is no positive injection current, and the corresponding V
IN
maximum must always be respected
V
SS
- 0.3 6.5
Input voltage on any other pin
(2)
V
SS
- 0.3 V
DD
+ 0.3
|V
DDx
- V
DD
| Variations between different power pins - 50
mV
|V
SSx
- V
SS
| Variations between all the different ground pins - 50
V
ESD
Electrostatic discharge voltage
see Absolute maximum
ratings (electrical
sensitivity) on page 86
-