Datasheet
STM32F103x8, STM32F103xB Electrical characteristics
45/84
Figure 20. Typical application with an 8 MHz crystal
1. R
EXT
value depends on the crystal characteristics. Typical value is in the range of 5 to 6R
S
.
Low-speed external clock generated from a crystal/ceramic resonator
The low-speed external (LSE) clock can be supplied with a 32.768 kHz crystal/ceramic
resonator oscillator. All the information given in this paragraph are based on characterization
results obtained with typical external components specified in Table 22. In the application,
the resonator and the load capacitors have to be placed as close as possible to the oscillator
pins in order to minimize output distortion and startup stabilization time. Refer to the crystal
resonator manufacturer for more details on the resonator characteristics (frequency,
package, accuracy).
Table 21. HSE 4-16 MHz oscillator characteristics
(1)
(2)
1. Resonator characteristics given by the crystal/ceramic resonator manufacturer.
2. Based on characterization, not tested in production.
Symbol Parameter Conditions Min Typ Max Unit
f
OSC_IN
Oscillator frequency 4 8 16 MHz
R
F
Feedback resistor 200 kΩ
C
L1
C
L2
(3)
3. For C
L1
and C
L2
it is recommended to use high-quality ceramic capacitors in the 5 pF to 25 pF range (typ.),
designed for high-frequency applications, and selected to match the requirements of the crystal or
resonator. C
L1
and C
L2,
are usually the same size. The crystal manufacturer typically specifies a load
capacitance which is the series combination of C
L1
and C
L2
. PCB and MCU pin capacitance must be
included (10 pF can be used as a rough estimate of the combined pin and board capacitance) when sizing
C
L1
and C
L2
.
Recommended load capacitance
versus equivalent serial
resistance of the crystal (R
S
)
(4)
4. The relatively low value of the RF resistor offers a good protection against issues resulting from use in a
humid environment, due to the induced leakage and the bias condition change. However, it is
recommended to take this point into account if the MCU is used in tough humidity conditions.
R
S
= 30 Ω 30 pF
i
2
HSE driving current
V
DD
= 3.3 V, V
IN
=V
SS
with 30 pF load
1mA
g
m
Oscillator transconductance Startup 25 mA/V
t
SU(HSE
(5)
5. t
SU(HSE)
is the startup time measured from the moment it is enabled (by software) to a stabilized 8 MHz
oscillation is reached. This value is measured for a standard crystal resonator and it can vary significantly
with the crystal manufacturer
startup time V
DD
is stabilized 2 ms
ai14145
OSC_OU T
OSC_IN
f
HSE
C
L1
R
F
STM32F103xx
8 MHz
resonator
R
EXT
(1)
C
L2
Resonator with
integrated capacitors
Bias
controlled
gain