Datasheet

Electrical characteristics STM32F100xC, STM32F100xD, STM32F100xE
72/105 DocID15081 Rev 8
Figure 25. 5 V tolerant I/O input characteristics - CMOS port
Figure 26. 5 V tolerant I/O input characteristics - TTL port
Output driving current
The GPIOs (general purpose input/outputs) can sink or source up to +/-8 mA, and sink or
source up to +/- 20 mA (with a relaxed VOL/VOH) except PC13, PC14 and PC15 it can sink
or source up to +/-3mA. When using the GPIOs PC13 to PC15 in output mode, the speed
should not exceed 2 MHz with a maximum load of 30 pF.
In the user application, the number of I/O pins which can drive current must be limited to
respect the absolute maximum rating specified in Section 5.2:
• The sum of the currents sourced by all the I/Os on V
DD,
plus the maximum Run
consumption of the MCU sourced on V
DD,
cannot exceed the absolute maximum rating
I
VDD
(see Table 7).
• The sum of the currents sunk by all the I/Os on V
SS
plus the maximum Run
consumption of the MCU sunk on V
SS
cannot exceed the absolute maximum rating
I
VSS
(see Table 7).
6$$

 
#-/3STANDARDREQUIREMENTS6
)(
6
$$

#-/3STANDARDREQUIRMENT6
),
6
$$













6
)(
6
),
6
6
$$
6
)NPUTRANGE
NOTGUARANTEED
AIB
6
)(
6
$$

6
),
6
$$



 
NOTGUARANTEED
)NPUTRANGE



44,REQUIREMENT6
)(
6
6
)(
6
$$

6
),
6
$$

44,REQUIREMENTS6
),
6
6
)(
6
),
6
6
$$
6
7
),MAX
7
)(MIN
AI
6
)(
6
$$

6
),
6
$$

"ASEDONDESIGNSIMULATIONS
"ASEDONDESIGNSIMULATIONS