Datasheet

DS9773 Rev 4 47/93
STM32F030x4/x6/x8/xC Electrical characteristics
75
Typical and maximum current consumption
The MCU is placed under the following conditions:
• All I/O pins are in analog input mode
• All peripherals are disabled except when explicitly mentioned
• The Flash memory access time is adjusted to the f
HCLK
frequency:
– 0 wait state and Prefetch OFF from 0 to 24 MHz
– 1 wait state and Prefetch ON above 24 MHz
• When the peripherals are enabled f
PCLK
= f
HCLK
The parameters given in Table 25 to Table 27 are derived from tests performed under
ambient temperature and supply voltage conditions summarized in Table 21: General
operating conditions.
Table 25. Typical and maximum current consumption from V
DD
supply at V
DD
= 3.6 V
(1)
Symbol
Parameter Conditions f
HCLK
All peripherals enabled
Unit
Typ
Max @ T
A
(2)
85 °C
I
DD
Supply current in
Run mode, code
executing from Flash
HSI or HSE clock, PLL on
48 MHz 22.0 22.8
mA
48 MHz 26.8 30.2
24 MHz 12.2 13.2
24 MHz 14.1 16.2
HSI or HSE clock, PLL off
8 MHz 4.4 5.2
8 MHz 4.9 5.6
I
DD
Supply current in
Run mode, code
executing from RAM
HSI or HSE clock, PLL on
48 MHz 22.2 23.2
mA
48 MHz 26.1 29.3
24 MHz 11.2 12.2
24 MHz 13.3 15.7
HSI or HSE clock, PLL off
8 MHz 4.0 4.5
8 MHz 4.6 5.2
I
DD
Supply current in
Sleep mode, code
executing from Flash
or RAM
HSI or HSE clock, PLL on
48 MHz 14 15.3
mA
48 MHz 17.0 19.0
24 MHz 7.3 7.8
24 MHz 8.7 10.1
HSI or HSE clock, PLL off
8 MHz 2.6 2.9
8 MHz 3.0 3.5
1. The gray shading is used to distinguish the values for STM32F030xC devices.
2. Data based on characterization results, not tested in production unless otherwise specified.