Datasheet

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
RSS-210 of the IC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
In the case where an OEM seeks the lesser category of a Class A digital device for the final product, the following
statement must be included in the final product manual:
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
RSS-210 of the IC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the interference at his
expense.
6.3 SRRC
6.3.1 Modular approval
The SPBTLE-1S module complies with Chinese SRRC certification.
– SRRC CMIIT ID: 2017DJ5956
6.3.2 Labeling instructions
When integrating the SPBTLE-1S into the final product, the OEM must ensure that the FCC labeling requirements
are satisfied. A statement must be included on the exterior of the final product which indicates the product
includes a certified module. The label should state the following (or similar wording that conveys the same
meaning):
This product uses SRRC approved Radio modular. CMIIT ID: 2017DJ5956
6.4 Bluetooth certification
The module with embedded stack and profile has been qualified in accordance with SIG qualification rules:
• Declaration ID: D034470
• Qualified design ID: 92838
• Product type: End Product
• Core spec version: 4.2
• Product description: Bluetooth Smart v4.2 module
SPBTLE-1S
SRRC
DS12065 - Rev 5
page 15/25