Datasheet

Absolute maximum ratings
LM158, LM258, LM358
4/23
DocID2163 Rev 12
2 Absolute maximum ratings
Table 1: Absolute maximum ratings
Symbol Parameter LM158,A LM258,A LM358,A Unit
V
CC
Supply voltage ±16 or 32 V
V
i
Input voltage 32
V
id
Differential input voltage 32
Output short-circuit duration
(1)
Infinite
I
in
Input current
(2)
5 mA in DC or 50 mA in AC
(duty cycle = 10 %, T = 1 s)
mA
T
oper
Operating free-air temperature range -55 to 125 -40 to 105 0 to 70 °C
T
stg
Storage temperature range -65 to 150
T
j
Maximum junction temperature 150
R
thja
Thermal resistance junction to
ambient
(3)
SO8 125 °C/W
MiniSO8 190
DFN8 2x2
(NB)
57
TSSOP8 120
R
thjc
Thermal resistance junction to
case
(3)
SO8 40
MiniSO8 39
TSSOP8 37
ESD
HBM: human body model
(4)
300 V
MM: machine model
(5)
200
CDM: charged device model
(6)
1.5 kV
Notes:
(1)
Short-circuits from the output to V
CC
can cause excessive heating if V
CC
> 15
V. The maximum output current is
approximately 40 mA independent of the magnitude of V
CC
. Destructive dissipation can result from simultaneous short circuits
on all amplifiers.
(2)
This input current only exists when the voltage at any of the input leads is driven negative. It is due to the collector-base
junction of the input PNP transistor becoming forward-biased and thereby acting as input diode clamp. In addition to this diode
action, there is NPN parasitic action on the IC chip. This transistor action can cause the output voltages of the Op-amps to go
to the V
CC
voltage level (or to ground for a large overdrive) for the time during which an input is driven negative. This is not
destructive and normal output is restored for input voltages above -0.3 V.
(3)
Short-circuits can cause excessive heating and destructive dissipation. R
th
are typical values.
(4)
Human body model: a 100 pF capacitor is charged to the specified voltage, then discharged through a 1.5 kΩ resistor
between two pins of the device. This is done for all couples of connected pin combinations while the other pins are floating.
(5)
Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between two pins of the
device with no external series resistor (internal resistor < 5 Ω). This is done for all couples of connected pin combinations while
the other pins are floating.
(6)
Charged device model: all pins and the package are charged together to the specified voltage and then discharged directly to
the ground through only one pin. This is done for all pins.