Datasheet

DocID025056 Rev 6 21/53
LIS2DH12 Application hints
53
4.1 Soldering information
The LGA package is compliant with the ECOPACK
®
, RoHS and “Green” standard.
It is qualified for soldering heat resistance according to JEDEC J-STD-020.
Leave “Pin 1 Indicator” unconnected during soldering.
Land pattern and soldering recommendations are available at www.st.com.
Table 13. Internal pin status
Pin# Name Function Pin status
1
SCL
SPC
I
2
C serial clock (SCL)
SPI serial port clock (SPC)
Default: input high impedance
2CS
SPI enable
I
2
C/SPI mode selection:
1: SPI idle mode / I
2
C communication enabled
0: SPI communication mode / I
2
C disabled
Default: input high impedance
3
SDO
SA0
SPI serial data output (SDO)
I
2
C less significant bit of the device address (SA0)
Default: input with internal pull-up
(1)
4
SDA
SDI
SDO
I
2
C serial data (SDA)
SPI serial data input (SDI)
3-wire interface serial data output (SDO)
Default: (SDA) input high impedance
5 Res Connect to GND
6 GND 0 V supply
7 GND 0 V supply
8 GND 0 V supply
9 Vdd Power supply
10 Vdd_IO Power supply for I/O pins
11 INT2 Interrupt pin 2 Default: push-pull output forced to GND
12 INT1 Interrupt pin 1 Default: push-pull output forced to GND
1. In order to disable the internal pull-up on the SDO/SA0 pin, write 90h in CTRL_REG0 (1Eh).