Installation guide

1. Make sure the base of the vanity is leveled by
laying a level across the top.
2. Set the vanity top on top of the vanity base,
checking the location of the p-trap and drain.
3. Remove the top and install the faucet per
manufacturer’s installation instructions.
4. Hand tighten the pop-up drain with a wrench. Be
careful not to over-tighten the pop-up drain. Over
tightening may cause cracks on the marble top.
5. Apply a thin bead of silicone compound around
the vanity base and set the vanity top carefully in
place. Remove any excess silicone compound with
a wet rag.
6. Attach water lines to faucet and connect the p-trap
and drain.