SPECIFICATIONS Wing span: Length: Wing area: Flying weight: Wing loading: PRODUCT MANUAL | Propeller 1200mm/47 .24in 13x4in Battery & ESC: 48 2200mAh AESCHYLUS Radio required: channel radio system SAFETY PRECAUTIONS This electric R/C model plans is not a toy. Assemble the plane according to the instructions. Do not alter or modify the model, If you make any modifications, you will void your warranty. Children under 14 years old must use it accompanied by an adult.
Lar dal l Before starting to build, inspect the parts to make sure they are of acceptable quality. If any parts are missing are not of acceptable quality, or if you need assistance with assembly, contact Product Support. When reporting defective or missing part, use the part names exactly as they are written in the Kit Contents List. 01. Fuselage . 16. Carbon rod . 02. Hatch... 16. Propeller 03. Left Wing 17. Propeller adapter x1 04. Right Wing .. 18. “Y” Servo Extension x1 05. Stabilizer. 19.
PREPARE THE RADIO CONTROL SYSTEM 1. Locate the transmitter (P1C.01). 2. The transmitter requires eight alkaline "AA" batteries. To install the batteries, remove the battery hatch by sliding it down and inserting them into place {PIC.02). Be sure to follow the polarity diagram inside the battery compartment. Reinstall the battery hatch {P1C.03}. CAUTION: (1). Do not use rechargeable (Ni Cd & NIH) batteries. (2). Do not mix old and new batteries. {3). Do not mix alkaline and standard (carbon zine) batteries.
ASSEMBLE THE MODEL Main Wing First, fix the push rods of aileron to the wings. Insert the carbon rod through one of the wings, and then put the other end of carton rod through the fuselage. Put the aileron servo wire through the fuselage into the battery cabin Main Wing 6.0x24mm Nylon screw MN ree 2 | a— Insert the carbon rod through the other wing. And also put the aileron servo wire through the fuselage into the battery cabin.
Main Wing 2.0x10mm Tapping screw Take the aileron servo wires and connect to the servo extension leads. Ensure the polarity should be contacted correctly. Mount the wiglets to the wingtip use M2.0x10mm tapping screws Tail Wing Take the stabilizer and slide it into the fuselage in right direction as shown Mount the fin to the fuselage.
Tail Wing 3.0x30mm Screw 2.0x10mm Tapping screw Fix the tall wing with the screw as shown Put the Z-bend of push rod Into the serve horn, then guide the push rod into the screw-lock connector on rudder/slevator horn and lock them Note: The longer push rod should be used for rudder, and the shorter one for elevator. Landing Gear 3.0x16mm Tapping scow Remove the locker of landing gear from the fuselage.
a Propeller and spinner of 2.5x14mm Screw Install the propeller adapter with retainer and propeller over the motor shaft. Put the propeller washer on the adapter shaft, and screw the nut onto the adapter. Tighten the nut with a hex wrench. ten the screws securely. If it comes off during flights, you may lose control of your airplane, resulting In an accident! Fix the spinner with the screw as shown. Battery & C.G Remove the battery hatch and install the battery. The standard C.
OPERATING YOUR MODEL SAFETY | Before Flying Flying After Flying | | Cautions for Safety | Before flying your airplane, ensure the airfield is spacious enough. Always fly It outdoors) in safe areas with no debris or obstacles! Do not fly your airplane on days with strong winds or tilde winds. [Always land plans Into the wind. EA WIND = men, fe |e For proper radii handing, refer to it's instruction manual.
