User's Manual

SPWF04SA, SPWF04SC
Regulatory compliance
*Note all data provided in this table are based on the Antenova reference board
FCC and IC
This module has been tested and complies with the FCC part 15 and IC RSS-247
regulations. These limits are designed to provide reasonable protection against harmful
interference in approved installations. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. The device must not cause harmful interference.
and
2. The device must accept any interference received, including interference that may
cause undesired operation.
Modifications or changes to this equipment not expressly approved by the party responsible
for compliance may render void the user's authority to operate this equipment.
The safe user distance, for RF Exposure, is ≥ 50mm (in compliance with 447498 D01
General RF Exposure Guidance v06 and RSS-102 Issue 5).
Modular approval, FCC and IC
- FCC ID: S9NSPWFS04
- IC: 8976C-SPWFS04
In accordance with FCC part 15, the modules SPWF04SA and SPWF04SC are listed above
as a modular transmitter device.
DocID025635 Rev 7 11/18