User's Manual

Getting started X-NUCLEO-S2868A1

DocIDxx

• a type A USB to mini-B USB cable to connect the STM32 Nucleo

board to the PC/laptop

• 128 MB of RAM

• Approximately 40 MB of hard disk space for the firmware

• Approximately 15 MB of hard disk space for the wM-Bus GUI

The use of the wM-Bus concentrator with the GUI requires additional boards

to be connected to the PC. The GUI can be used to check the wM-Bus

communication sample.

2.3 Board setup

Perform the following steps to set up the board:

Step 1. Check that the jumper on J1 connector is connected to provide the

required voltage to the board devices.

Step 2. Connect the X-NUCLEO-S2915A1 to the STM32 Nucleo board as

shown in Figure 2. X-NUCLEOS2915A1 expansion board connected to an

STM32 Nucleo development board

Step 3. Power the Nucleo development board using the Mini-B USB cable

Step 4. Program the firmware in the STM32 on the Nucleo development

board using the firmware sample provided

Step 5. Reset the MCU board using the reset button on the Nucleo

development board

Step 6. The evaluation kit is ready-to-use