User's Manual

SPBT2425C2DB.xxx
rev. 1.0 18-Jun-07 5/9
5 - DOWNLOADING
SPBT2425C2DB.xxx has also the possibility to be downloaded with a file developed by the user
To download a file into SPBT2425C2DB.xxx the following basics steps must be followed:
- connect the board to a PC by means a RS232 cable connected on COMx port
- put a jumper on JP6 ( Boot pin to low level)
- connect the power supply cable to the board at +5V ext Vin
- open the “Flash loader “ program
- choose UART on Transportation layer section
- choose the appropriate COMx port
- with Browse , choose the firmware file to be downloaded
- Select “Firmware” in both the sections Erase and Download
- If Info Page must be rewritten choose Info Page in Erase and Download sections
- press start : on the dialog bar will appear “ reset the board”
- press S2 (reset) ( a reset is generated) : on the dialog bar will appear the % of the downloading.
- At the end of the downloading a “successful ” or “fail “ message will appear.