User's Manual Part 1

GSBT2416C2DB.xxx
rev. 1.0 18-Jun-07 7/13
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help.
Antenna
Our board type GS-BT2416C2DB.xxx is for OEM integrations only. The end-user product will be
professionally installed in such a manner that only the authorized antennas are used.
Caution
Any changes or modifications not expressed approved by the party responsible for compliance could cause the module to cease
to comply with FCC rules part 15, and thus void the user’s authority to operate the equipment.
Label instruction
Module type : Bluetooth class 2 board GSBT2416C2DB.xxx (GSBT2416C2 module + PC 787 carrier
board)
FCC-ID : S9N16C2
This intends to inform you how to specify the FCC ID of our Bluetooth board GSBT2416C2DB.xxx on your final
product.
Based on the Public Notice from FCC, the product into which the our transmitter module is installed must display a
label referring to the enclosed module.
The label should use wording such as “Contains Transmitter module FCC ID: S9N16C2 or “Contains FCC ID:
S9N16C2, any similar wording that expressed the same meaning may be use.
It shows an example below
Contains FCC ID: S9N16C2