User's Manual Part 1

GSBT2416C2DB.xxx
rev. 1.0 18-Jun-07 5/13
5 - DOWNLOADING
GSBT2416C2DB.xxx has also the possibility to be downloaded with a file developed by the user
To download a file into GSBT2416C2DB the below items must be followed:
- connect the board to a PC by means a RS232 cable connected on COM1 / COM2
- put a jumper on JP1 ( Boot pin to low level)
- connect the power supply cable to the board at +5V ext Vin
- open the “Flash loader “ program
- choose UART on Transportation layer section
- choose the appropriate COM1 / COM2 port
- choose the firmware to be downloaded on “Firmware “ section
- press start : on the dialog bar will appear “ reset the board”
- power the board ( a reset is generated) : on the dialog bar will appear the % of the downloading.