User's Manual Part 1

GSBT2416C2DB.xxx

rev. 1.0 18-Jun-07 12/13

POINT to POINT CONNECTION

Modules with AT commands firmware can only perform point to point connection which means only a connection per

time can be activated.

A module can be connected with several other modules but it has to disconnect the previous connection before to

activate a new one.

Suppose to have a Client C1 which need to connect with Server S1,S2,..Sn :

In this case the procedure to follow is the following :

- C1 will establish the connection with S1 exchanging the data

- C1 will disconnect S1 with the command AT+BTDISCONNECT

- C1 will establish the connection with S2 exchanging the data

- C1 will disconnect S2 with the command AT+BTDISCONNECT

- C1 will establish the connection with Sn exchanging the data… an so on