Installation Instructions

6
 Lay the plank in place, making sure that the cut edge is against the wall.
6. FITTING AROUND IRREGULAR OBJECTS
 Make a pattern out of heavy paper to fit around pipes and other irregularities.
 Place the pattern on the plank, trace cutting along the trace lines.
7. CUTTING
Use a simple utility knife and ruler, and with the top side facing up, cut heavily and several times on the
same axis. The knife will not go through the surface but make a deep cut. You can then lift one half of
the plank using your other hand to hold down the second placing it very close to the cut. The plank will
split naturally.
IV. FINISHING THE INSTALLATION
 The glue must be able to cure 100% before moving in furniture. Hence, leave the floor untouched
for 24 hours after installation between 65°F / 20°C and 77°F / 25°C for the curing process to
complete.
 Wait at least 4 hours before walking on your new installed vinyl floor.
 For rooms with a high moisture level like bathrooms, a waterproof transparent silicone must be
used around the perimeter.
 Replace molding or wall base, allowing slight clearance between the molding and the planks.
 Nail the molding to the wall surface, not through the flooring.
 At doorways and at other areas where the flooring planks may meet other flooring surfaces, it is
preferable to use a “T” molding, or similar, to cover the exposed edge but not pinch the planks.
 Leave a small gap between the planks and the adjoining surface.
V. MAINTENANCE
 Sweep or vacuum daily using soft bristle attachments.
 Clean up spills and excessive liquids immediately.
 Damp mop as needed and use cleaners recommended for vinyl flooring.
 The use of residential steam mops on this product is allowed. Use at lowest power with a suitable
soft pad, and do not hold a steam mop on one spot for an extended period of time (longer than 5
minutes). Refer to the steam mop's manufacturer instructions for proper usage.
 Use proper floor protection devices such as felt protectors under furniture.
 Place a walk-off mat at outside entrances to reduce the amount of dirt brought into your home. Do
not use mats with a latex or rubber backing since these backings can cause permanent
discoloration.
 Do not use abrasive cleaners, bleach or wax to maintain the floor.
 Do not drag or slide heavy objects across the floor.
For Customer Service, Call or Email:
[phone] or [phone]
[e-mail]