User's Manual

ST Engineering Telematics Wireless Ltd
14
8.2 Installation without the GPS components
8.2.1 CSV file
During the installation, the installer needs to obtain and record the following required commissioning
information in a CSV file:
• Unit ID/serial number of the installed LCU NEMA
• Pole number (if any)
• GPS coordinates obtained using a handheld GPS device. See
8.2.2. Options for Obtaining GPS
Coordinates.
Telematics provides a sample commissioning CSV file to customers for recording the required information.
Note: Before beginning the installation, it is important to decide which additional information
the installer should obtain for the Post-Installation Commissioning, if any. For the additional
equipment information, see Appendix B. Commissioning CSV File
.
8.2.2 Options for Obtaining GPS Coordinates
The following options refer to customer-supplied equipment:
• Smartphone with internal GPS receiver:
◦ Enable Location services.
◦ Set Locating method at High accuracy or similar.
• Smartphone with external GPS device:
◦ Disable Location services: Location services are turned off.
◦ Install and pair external GPS device.
• Handheld GPS device:
◦ Follow manufacturer’s instructions for obtaining high accuracy coordinates.
8.2.3 Installation
1. Record the LCU NEMA unit ID /serial number and pole number, if any.
2. Standing as close as possible to the pole, obtain the GPS coordinates for the pole using one of the
options described in 8.2.2. Options for Obtaining GPS Coordinates
.
3. Record the coordinates for the LCU NEMA in a CSV file.
4. Install the LCU NEMA. See 9. Installing the LCU NEMA
.
5. Observe the ON/OFF light sequence that verifies the LCU installation. See 9.1 Observing the “Auto
Detection and Verification” Procedure.
6. After each LCU NEMA installation, the installer has the following options for providing the
commissioning information to the CMS Administrator: