Installation Manual
Master Meter, Inc. 101 Regency Pkwy, Mansfield, TX 76063 T: 817-842-8000 F: 817-842-8100 MasterMeter.com
1. Introduction
The Allegro Wall mount endpoint for wáter meters provides two-way communication capabilitiblites over the
Allegro RF Network to transmit encoded wáter meter readings, alarms, and other related functions. The Allegro
Wall mount endpoint is battery operated and utilizes an FCC licensed frequency within the 450- 470Mhz band.
The following are the main features of the Allegro Wall mount endpoint:
On request reads for last-time meter reads
Alarm report & data logging
Remote, over-the-air firmware upgrades
Remote unit configurations
Confirmation of network connectivity
2. General Information
Read the instructions below before installing the endpoint.
To prevent injury or damage, do not install, operate, or maintain the endpoint without following the
instructions in this guide.
Store the endpoint in a cool, dry place.
Follow all warnings and instructions marked on the product.
3. Unpacking and handling
Carefully unpack the endpoint and inspect all contents for shipping damage before attempting to install.
If any indication of physical damage is found, immediately contact the responsible transportation service
and your local Master Meter representative.
Avoid hard blows, jolts, or impact to the endpoint.