User's Manual

sϭϭϬ

)HDWXUHV

x6PDOODQGIODWSURILOH

x/LJKWZHLJKW

x&:DQGSXOVHPRGHRSHUDWLRQ

x/RZFXUUHQWFRQVXPSWLRQ

$SSOLFDWLRQV

x/LJKWLQJFRQWURO

x0RWLRQGHWHFWLRQ

x6HFXULW\DODUP

x$XWRPDWLFGRRUFRQWURO

The AP98 series ceiling-mount K-band microwave sensor is a Doppler transceiver with a HEMT

oscillator, a single balanced mixer and bi-static microstrip patch antennas. It is suitable for ap-

plications in lighting control, automatic access and security.

Its lightweight, miniature size and slim profile offer the flexibility to OEMs in making trendy and

slim products.

$3

&HLOLQJ-0RXQW.-EDQG0LFURZDYH6HQVRU

Pin Name Description

1 +V Supply voltage, V

2 IF IF output

3 GND Ground

All dimensions are in mm.

Note 1: Complies with EN 300 440.

Note 2: Complies with FCC Part 15.245.

Note 3:

CAUTION: ELECTROSTATIC SENSITIVE DEVICE.

Observe precautions for handling and storage.

0RGXOH2XWOLQH

PAGE 1
$3 )HDWXUHV &HLOLQJ-0RXQW .-EDQG 0LFURZDYH 6HQVRU x 6PDOO DQG IODW SURILOH x /LJKW ZHLJKW x &: DQG SXOVH PRGH RSHUDWLRQ x /RZ FXUUHQW FRQVXPSWLRQ $SSOLFDWLRQV x /LJKWLQJ FRQWURO x 0RWLRQ GHWHFWLRQ x 6HFXULW\ DODUP x $XWRPDWLF GRRU FRQWURO The AP98 series ceiling-mount K-band microwave sensor is a Doppler transceiver with a HEMT oscillator, a single balanced mixer and bi-static microstrip patch antennas. It is suitable for applications in lighting control, automatic access and security.
PAGE 2
$QWHQQD %HDP 3DWWHUQ %ORFN 'LDJUDP 90 Normalized Radiation Pattern (dB) 0 120 X Y 60 -10 -20 150 30 -30 -40 180 0 -30 -20 210 330 -10 0 240 300 270 * Antenna beam pattern is based on simulations. Illustration assumes ceiling mounted sensor directed towards the ground. 7HFKQLFDO 6SHFLILFDWLRQV Unless noted otherwise, the specifications are measured in CW mode, V IN = +5 VDC and 12 kohm load at +25°C. Parameter Remarks Min Typical Max Units AP98, AP98-1 4.75 5 5.
PAGE 3
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.