Owner's Manual

5
RUNNING AMP POWER CABLE AND REAR SPEAKER WIRE
AMP PLATE INSTALLATION
Place the pre-assembled amp plate on the frame of the dash and line up the hole on the top of the amp plate to the factory hole
where the pocket bracket was previously installed (1). Loosely screw in the factory 10mm screw in this hole location.
Next loosely screw in the M6 screw with washer from underneath the steering column into the amp plate (2).
Lastly hand tighten both screws.
11
2
2
Connect the amplier input
to the Ride Command “Audio
Amp 3” factory harness.
Then connect the power/
ground to the amplier.
A1 A2 A3
A. Starting from under the hood compartment, feed the connector of the power wire through the grommet into the dash cavity. In order to connect to the
amplier in a later step, pull about 18” of the amp power wire into the dash cavity (A1). Route the additional length of the (ring terminal end) power/
ground wire down the exterior of the rewall along the factory wiring (A2). Pull the power/ground wire through to the center of the vehicle to the battery
compartment. DO NOT CONNECT TO THE BATTERY (A3).