Owner's Manual

W. Place MRB3 dash mount onto the center cup holder panel , and scribe the 4
comer mounting points . Make pilot holes using a 3/32" drill bit.
Y. Place MRB3 controller in controller mount and fasten down
with provided screws .
X. Drill out the center of the cup holder for the controller cable
to be routed through with a 9/16" drill bit.
NOTE : Control drill bit depth to avo id puncturing through
other side of cup holder .
II
Z. Route MRB3 controller cable through cup holder
Al. Fasten the dash mountto cup holder with provided screws .
• I
B2. Connect the antenna.
B2. Connect the MRB3 controller to the brain .
B3 . Connect the power/ground wire .