Owner's Manual

SSV WORKS , 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks . com I Phone : 818 - 991 - 1778 I Fax: 866- 293 - 6751
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects
in material or workmanship. All SSV Works Electronics are covered by a limited 1 year
warranty against defects in material or workmanship. All SSV Works Speakers are
covered by a limited 1 year warranty against defects in material or workmanship. Labor
for replacement of defective components is not covered. Contact SSV Works for further
warranty information.
TOOLS NEEDED FOR INSTALLATION
RZ4-GB10-M
RZR Turbo S & RZR XP1000 2018+
Glove Box Subwoofer Enclosure
A
Please read and understand these
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
-Wire Crimpers ·
- Drill with 1/8 " and 1/4"
Drill bits
- T-40 Torx Driver - #2 Phillips Screwdriver
- Wire Strippers
-10mm Socket or Wrench
PARTS LIST IMAGES
1. WP-RZ3GBS10 Enclosure
(door not included)
• •
• •
5. Large Flat Mounting
Bracket
INSTALLATION NOTES
- T-30 Torx Driver
2. 8mm Socket Head Screw x 9
6. Small Flat Mounting
Bracket
. '
- #3 Phillips Screwdriver
3. M6 x 8mm Screws x 2
(Short)
7. "L" Bracket x 1
- Panel removal tool
4. M6 Washers x 9
8. Glove Box Door
Bracketx 1
The use of a thread locker is recommended on all screws to prevent loosening due to vibration. If the vehicle has SSV Works front kick panels
(RZ4 - F65/RZ3-F65) installed, the passenger side kick panel will need to be removed prior to installation of the RZ4-GB 10. Removal of the
passengerfender is not required (Step 3); however it will make the installation and alignment of the RZ4-GB10 easier.