User Guide ssv MRB3 1111:JRICS TRACK @ {Moo~ MRB3 Bluetooth Media Controller I' SAFETY INFORMATION Do not attempt to disassemble or repair the MRB3 yourself. Please call SSV Works for technical assistance or repair information. Changes or modifications to the MRB3 not authorized by SSV Works will void the warranty. A ~ SSV Works recommends disconnecting the negative battery termlnal before beginning any lnstallatlon.
I AMPLIFIER WIRING DIAGRAM Power connector Yellow 12A 12v+ Yellow--@-Black Black ,-----,"'1__ Rear left(+) Green-m- Rear left(-) Green/Black Rear left(+) Green Rear left(-) Green/Black Rear right(+) Purple--00- Rear right(-) Purple/Black Rear right(-) Purple/Black Rear speaker Rear right(+) Purple Front left(+) White Front right(+) Grey Front left(-) White/Black .
BUTTON LOCATIONS AND FUNCTIONS - ..-------- -------- 1. Play/Pause Power On/Off Mute 2. Volume Up/Down © VOL ~ - - - - _ , TRACK 9~, e e @ ~ ~ o e 3. Mode 4. Track Forward/Back Station Forward/Back Menu Settings Up/Down 5. LCD Display GENERAL OPERATIONS Power On/Off: Press ►II to power on. Press and hold ►II to power off. Volume: Press the VOL(+) or(·) button to increase or decrease the volume. Mute On/Off: Press ►II briefly to mute the sound. Press ►II again to un-mute the sound.
RADIO FUNCTIONS Selecting FM/AM Band: Press MODE until the FM or AM band shows on the display. Automatic Station Search: Press A or ¥ to start automatic station search. The search stops when a station is found. Manual Station Search: Press and hold A or ¥ until M - SEEK. Press the A or ¥ briefly to change the frequency until the desired frequency is set. Change to Automatic search (A - SEEK) mode after a station is found. I BLUETOOTH AUDIO STREAMING 1.
WP3-PN304A Honda Pioneer 1000 4 Speaker Overhead WP System SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030 www.SSVworks.com I Phone: 818-991-1778 I Fax: 866-293-6751 WARRANTY INFORMATION: All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against defects in material or workmanship.
A. Loosely install the (2) mounting brackets onto the top of the enclosure using (8) Phillips Screws and (8) washers. Brackets are marked with a D (driver) or P (passenger) for correct orientation. B. The enclosure brackets will utilize one safety net bolt on each side. Remove both with a 10mm socket C. Place the WP3-PN304A onto the cage with the (2) J style brackets resting on the front of the cage. D.
WP ADD-ON AUX INPUT & 2.1A use CHARGE PORT Want to add an aux 3.5mm input to your WP Overhead Stereo System or charge your media player? We've got you covered with an aux input and USB charge port. Mount it in the glovebox or replace your dash power port. It simply plugs into your WP system and wires to accessory power. At only 1.5" wide.
