Data Sheet

General Note: SST Sensing Ltd. reserves the right to make changes to product specifications without notice or liability.
All information is subject to SST Sensing Ltd.'s own data and considered accurate at time of going to print.
DS-0130 REV 5
© 2018 SST SENSING LTD.
CAUTION
Do not exceed maximum ratings and ensure sensor(s) are operated in
accordance with their requirements.
Carefully follow all wiring instructions. Incorrect wiring can cause
permanent damage to the device.
SST Sensing Ltd recommend using alcohol based cleaning agents.
Do NOT use chlorinated solvents such as trichloroethane as these are
likely to attack the sensor material.
Failure to comply with these instructions may result in product
damage.
INFORMATION
As customer applications are outside of SST Sensing Ltd.’s control, the
information provided is given without legal responsibility. Customers
should test under their own conditions to ensure that the equipment is
suitable for their intended application. Before use, check that the fluid in
which you wish to use these devices is compatible with Stainless Steel
and glass.
MOUNTING SPECIFICATIONS
NOTE: Fixing nut and O-
G2x0 & G6x0 Series G7x0 & G8x0 Series
ORDER INFORMATION
Generate your specific part number using the convention shown below. Use only those letters and numbers that correspond to the
sensor and output options you require — omit those you do not.
Housing
Type
Output
Logic
Supply
Voltage
Output
Type
Termination
2
2x0 series
M12x1
L
Output
Low in air
24
8-30V
DC
001
N-Type
with flyback
Blank
Flying Leads
24AWG 0.2mm
6
6x0 series
1/2”-20 UNF
Blank
Output
High in air
Blank
4.5-15.4V
DC
002
N-Type with
10kΩ pull-up
D
M12 4-pin
male connector
(IP67)
7
7x0 series
1/4” NPT
003
N-Type
8
8x0 series
1/2” NPT
004
P-Type
005
N&P
Push Pull
L L G
X
1 0 D 3
X X
-
X X X X
-
X