Produktinformation Bus-Schalt-Einheit BSE 650-0 Bus switching unit BSE 650-0 Unité de commutation bus BSE 650-0 Unità di comando bus BSE 650-0 Bus-schakel-eenheid BSE 650-0 Busstyreenheden BSE 650-0 Buss-kopplings-enhet BSE 650-0 Sběrnicová spínací jednotka BSE 650-0
ON 1 2 1 Sek. 4 3 4 Sek.
Sek. 7 4 Sek. 1 Sek. 9 8 4 Sek. 1 Sek.
1-59 Sek. 1 Min. 12 4 Sek. 4 Sek. 14 13 4 Sek.
English Montage Technische Daten • Versorgung der Busschnittstelle erfolgt aus dem YR-System-Bus • Kontaktbelastung max. 250 V AC, 6 A, Stromkreisabsicherung mit max.10 A • Kontaktbelastung min. 5 V / 100 mA 10 V / 10 mA 24 V / 1 mA • Zulässige Schaltleistungen: - Motore max. 3 A - Glühlampen max. 1300 W - Energiesparlampen: max. 18 x Silvania 7 W oder 12 x Osram 11 W - Leuchtstofflampen unkompensiert cos ϕ 0,5 max. 800 VA - Duo-Leuchtstofflampen max. 1200 VA - Parallelkompensierte Leuchtstofflampen max.
the buttons BTS/BTC 750-... and BTLM 650-... for actuation can be manually programmed. For programming a key and an LED as a status display and functional testing are available. Defining call buttons for actuation of the BSE 650-... which actuate the BSE 650-... with the function „secondary signal controller“ in parallel to a BTS/BTC 750-... . Defining control buttons for actuation of the BSE 650-... . Important! No BTLM 650-... or BTLE 051-... is active.
Switch off the programming mode at the BSG 650-... The status LED goes out, operating status of the overall system. Fig. 6 Defining the bell buttons for actuation of the BSE 650-... Important! The BTLM 650-... or BTLE 051-... is active. Programming the BSE 650-... is only possible if the YR system is active. Switch the BSG 650-... to the programming mode; The status LED flashes evenly. Fig. 2 BTLM 650-... or BTLE 051-... activated Fig. 13 Deleting the bell buttons for actuation of the BSE 650-...
Français Montage programming mode and saves the minimum time of 0.4 secs. If the key at the BSE is actuated several times, each actuation increments the time setting up to a maximum of 19 minutes. The time of the last actuation corresponds to the number of seconds which is added to the minutes. Example For a time setting of 3 mins. 15 secs. , actuate the Programming mode button at the BSE 4 times, releasing the button on the last actuation only after 15 secs. Maximum time setting 19 minutes, 59 seconds.
