SSK-DK100 User Manual
1.Notice： 1.The Newly added HDD must be partitioned and formatted in the disk management before using. 2.Do not drop anything or hit this product. Please do not use the unit in places where the temperature is too high, too low or humid. Do not dismantle, repair or manufacture without authorization. 2. Packing List： ① DK-100 Docking ② USB3.
.Device interfaces and LED introduction Four LED Indicators Green, Red, Yellow and Orange HDD-B HDD-A USB3.
. Features/Specifications Supports 2.5-inch SATA I/II/III HDD/SSD and 3.5-inch SATA I/II/III HDD,2.5 inches support up to ４TB, 3.5 inches support up to １０TB; • Support USB3.0 high speed transmission; • Easy to install, plug and play, hot swap; • LED progress indicator; • Support one-click hard drive copy; • Measurement: 129 (L) x 96 (W) x 72 (H) mm • Compatible with Windows, Mac and Linux operating systems. 5、Product Working Mode Introduction (Mobile hard drive mode) • Install the 2.5/3.
always on and the blue light is flashing. • After around 3-5 seconds, Computer detect new hardware. LED Indicator Color Instructions: • When Docking is turned on, the green light is always on; • After hard drive connected, the blue light turns on,the blue light flashes under reading and writing.
LED Indicator Color Instructions: • When Docking is turned on, green LED is always on • When the clone mode starts, 4 LED lights flash alternately (Green,Red,Yellow,Orange) • Clone progress indicator: 25% completed, green lights on; 50% completed, red lights on; 75% completed, yellow lights on; 100% completed(4 LEDs light on at the same time, green + red + yellow + orange) Note: In clone mode, the device cannot be connected to your computer via a USB cable.
