SSD Pro44 Portal Rear Axle Assembly Manual

SSD Pro44 Portal Rear Axle Assembly Instructions

Note: The stock SCX10 II AR44 axles will need to be disassembled with all

gears, bearings and shafts removed before starting.

1 Install tubes into the housing

SSD-RC.com 1 Pro44 Portal Rear Axle

PAGE 1
SSD Pro44 Portal Rear Axle Assembly Instructions Note: The stock SCX10 II AR44 axles will need to be disassembled with all gears, bearings and shafts removed before starting. 1 Install tubes into the housing SSD-RC.
PAGE 2
Install gears with bearings Apply grease to the gears before installation Be careful not to over tighten the screws SSD-RC.
PAGE 3
Install diff cover 4 Install axle shafts and bearings SSD-RC.
PAGE 4
Steps 4 to 8 should be completed on both sides 5 Attach portal gear case SSD-RC.
PAGE 5
6 Install bearings SSD-RC.
PAGE 6
7 Install gears Apply grease to the gears SSD-RC.
PAGE 7
8 Install cover The assembled axle can now be installed on the chassis. Hexes and wheels can be fitted in the usual way. SSD-RC.