SSD 2-Speed Conversion Manual

SSD 2 Speed Conversion for SCX10 II Assembly Guide

Note: The stock SCX10 II transmission needs to be removed from the

chassis and disassembled before starting.

1 Shift fork/rod assembly

2 Top shaft assembly

SSD-RC.com 1 SCX10 II 2 Speed Conversion

PAGE 1
SSD 2 Speed Conversion for SCX10 II Assembly Guide Note: The stock SCX10 II transmission needs to be removed from the chassis and disassembled before starting. 1 Shift fork/rod assembly 2 Top shaft assembly SSD-RC.
PAGE 2
3 4 SSD-RC.
PAGE 3
5 Install bearings in gears 6 SSD-RC.
PAGE 4
7 SSD bottom shaft assembly 8 Install gears SSD-RC.
PAGE 5
9 Install washers and bearings 10 Insert shift fork into the assembly SSD-RC.
PAGE 6
11 The entire assembly can now be installed in the Axial SCX10 II transmission case. The transmission case then needs to be reassembled and installed back into the chassis as shown in the SCX10 II assembly manual. Use plenty of grease during assembly. 12 Attach servo mounts from the kit onto your shift servo. Attach the servo to the chassis using the hardware and spacers provided. SSD-RC.
PAGE 7
13 The shift link will need to be attached to the transmission shift rod using the hardware provided. The other end needs to be attached to the shift servo. Note: A 3 channel radio is needed in order to connect the shift servo and change gears. SSD-RC.