Cut Sheet

© 2016 Littelfuse Protection Relays & Controls
Flashers and Tower Lighting Controls
Flashers
www.littelfuse.com/fs100Lowcurrent
Rev: 1-A-062116
Specications
Wiring Diagram
FS100 SERIES
Description
The FS100 Series (low current) may be used to control inductive,
incandescent or resistive loads. This series offers a 1A (fullwave)
or a 2A (halfwave) steady state, 10A inrush solid-state output
and may be ordered with an input voltage of 24 or 120VAC. The
FS100 Series offers a factory fixed flash rate of 75 FPM or may
be ordered with a fixed, custom flash rate ranging from 45 to
150 FPM. Ideal for OEM applications where cost is a factor.
Operation
Upon application of input voltage, the T2 OFF time begins. At
the end of the OFF time, the T1 ON time begins and the load
energizes. At the end of T1, T2 begins and the load de-energizes.
This cycle repeats until input voltage is removed.
Reset: Removing input voltage resets the output and the
sequence to T2.
Features & Benefits
FEATURES BENEFITS
Compact Size:
38 x 23.9mm (1.5” x 0.94”)
Ideal for OEM applications
Custom Flash
Rates Available
Tailor to specific application: custom rates range
from 45 to 150 FPM
Accessories
P1023-2 “P” Clamp
Mounting Bracket Alum. 15/16
Low Current Flasher
Ordering Information
MODEL INPUT VAC OUTPUT RATING A OUTPUT TYPE AC LOAD TYPE FLASH RATE
FS126 120 1 Fullwave Incandescent & Resistive 75 FPM
FS126-45 120 1 Fullwave Incandescent & Resistive 45 FPM
FS126-60 120 1 Fullwave Incandescent & Resistive 60 FPM
FS126RC 120 1 Fullwave Incandescent, Resistive, & Inductive 75 FPM
FS126RC-45 120 1 Fullwave Incandescent, Resistive, & Inductive 45 FPM
FS127 120 2 Halfwave Incandescent & Resistive 75 FPM
FS146 24 1 Fullwave Incandescent & Resistive 75 FPM
FS146RC 24 1 Fullwave Incandescent, Resistive, & Inductive 75 FPM
If you don’t find the part you need, call us for a custom product 800-843-8848
L1 N
V = Voltage
L = Load
R = Red Wire
B = Black Wire