Programming Instructions

LD2342 V1.3 Page 15 of 21
SRT Marine
User guide
SRT-MTB
©
proAIS Application
Software update tab
This tab provides the facility to update the AIS transponder's internal software.



CAUTION:
Only perform a software update using an update file intended for use with the SRT-MTB© product.
Do not interrupt the power to the unit or disconnect from the PC during the update process unless instructed
to do so by the proAIS application.
1. Click the 'Select update file' button and navigate to the update file. This will have the extension .hex
2. Click the 'Start update button'
3. Follow the instructions provided underneath the update progress bar.
4. Depending on the AIS software version you may be requested to power cycle the unit at two points in the process.
Turn the power supply to the AIS off and back on again at these requests. Do not disconnect the serial connection to
the PC.
5. Once the 'Update completed' is displayed the AIS is ready for use
6. Please verify the information shown on the static data tab is correct after any software update.