User's Guide
11
10
Crank InstallatIon
Adhesive Putty instAllAtion
adhesIve putty InstallatIon
The included adhesive putty will permanently attach the magnet to your frame. Other non-permanent
attachment options include: hot glue, some epoxies, electrical tape, or similar adhesives.
Installation Notes: Do not allow the magnet to contact the power meter. When properly installed, the
magnet should be in line with the cadence sensors and within 2-8 mm (1/16”-3/8”) of the sensors.
Depending on your frame, you may need to stack 2-3 magnets to achieve this distance.
1. Remove the existing cranks.
2. Clean the frame with the included alcohol pad prior to attaching the magnet.
3. Knead both colors of adhesive putty with your ngers until you have one consistent color.
4. Place a 6 mm (1/4”) diameter ball of putty on the back of the magnet, and then press the magnet onto
the frame. The center of the magnet should be positioned between 30 mm and 38 mm (1 1/8”-1 1/2”)
from the center of the bottom bracket.
5. Use a toothpick to carefully remove any excess putty before it dries. The putty will set up in about 10
minutes, and will cure in 1 hour.
6. Reinstall the cranks.
7. Conrm the magnet is within 2-8 mm (1/16”-3/8”) of the sensor.
2
1
10
0
20
30
40
3
4
5
7
8
6
9
2
1
3
4
130
140
8
9
2
1
3
4
5
mm/inch
OFF
ON
ZERO
100
120
2
1
3
4
5
7
6
CRANK INSTALLATION
Install the crankset and bottom bracket assembly onto your bike according to the manufacturer’s
instructions.
Once the crankset has been installed, the power meter must not contact the frame or any other
components. Please contact Quarq customer service with any frame compatibility questions. An updated
list of compatible frames is available at Quarq.com.
SET UP
led FunCtIonalIty
The LED provides useful information about the operating condition of the power meter. See the ‘Self-Test’
in the Troubleshooting section for more LED information.
The LED will ash:
• twice when battery is inserted
• once when waking.
• once when nished zeroing (calibration)
• once when entering the sleep state.