User Manual

V-CV EXPANDER
Vortices CV expander adds voltage
control of the signal levels for the 3 stereo and
4 mono main inputs.
The switch located near the expansion
header, between the panel and PCB must be
set in the EXP position when the expander is
connected.
The supplied 10pin cable must be
connected in the same orientation on Vortices
and V-CV. Red stripe down.
With V-CV connected the functioning of
Vortices remains the same. Once a Control
signal is patched, the respective channel
attenuator adjusts the level of the incoming
CV, allowing level and saturation to be auto-
mated. The CV source should be near 10V for
full scale behavior.
B
A
A
A
A
B
B
B
B
QUICK-VIEW: V-CV Expander
Stereo Mixer CV Inputs
Mono Mixer CV Inputs
6
6