Product Overview

Product data sheet
Mounting and Clearance
ZB6CD28
Pushbuttons, Switches and Pilot Lights for Printed Circuit Board Connection
Front Panel Cut-out (Viewed from Installer’s Side)
Printed Circuit Board Drillings (Viewed from Electrical Block Side)
A 24mm/0.94in. minimum for rectangular heads, 18mm/0.71in. minimum for square or circular heads
B 18mm/0.71in. minimum
(1) 6x Ø1.1mm / 6xØ0.04in. holes.
(2)
1xØ2.6
0
-0.2
mm / 1xØ0.10
0
-
-0.008
in. hole for locating pin, only when using socket adaptor ZB6Y010.
(3)
1xØ3.2
0
-0.2
mm / 1xØ0.13
0
-0.008
in. hole for fixing of printed circuit board onto the front panel using body bracket ZB6Y011. This hole must be drilled on the left-hand side, when heads are positioned at the normal angle. Fit a body bracket ZB6Y011 every 72mm/2.83in. maximum for cut-outs on 24mm/0.94in. centres (rectangular heads) and 54mm/2.13in. maximum for cut-outs on 18mm/0.71in. centres (square or circular heads).
General tolerances of the panel and printed circuit board: T1, T2: T1+T2=0.3mm/0.01in. maximum.
Installation precautions:
Thickness of printed circuit board: 1.6mm/0.06in. minimum.
5