Instructions / Assembly
Table Of Contents
- Square D™ Safety Switch User Manual
- Safety Information
- Installation and Operation Requirements
- Exposure to Moisture, Chemicals, and Condensation
- Installation
- Fusible Safety Switches
- Class R Rejection Clip Kits
- Non-Fusible Safety Switch Short Circuit Current Rating
- Ground Kits
- Insulated Neutral Assemblies
- Line Side Barriers
- Service Entry Requirements
- Maintenance
- Wiring Diagrams
- Replacing the Viewing Window 30–200 A
Installation and Operation Requirements Class 3130 / 3110
Installation and Operation Requirements
This equipment does not achieve its ratings until it is installed per record/as-built
drawings, installed per the instructions contained in this document, and has
operational environmental controls with appropriate settings to help mitigate
environmental influences. This equipment can also be operated in a climate controlled
area that uses both heating and cooling to maintain acceptable environmental
conditions. Indoor and outdoor rated equipment is not suitable for outdoor storage. In
some cases (such as seasonal electrical loading, de-energized equipment, and
standby/alternate power sources), the heat generated by equipment loading is
insufficient to prevent condensation and alternate heat sources are required. If
environmental controls such as a thermostat or humidistat are used, ensure their
settings are sufficient to mitigate condensation and remain operational at all times.
Consult the Engineer of Record for the appropriate environmental control settings.
Proposition 65 Information
WARNING: This product can expose you to chemicals including Lead and Lead Compounds,
which are known to the State of California to cause cancer and cause birth defects or other
reproductive harm. For more information go to www.P65Warnings.ca.gov.
GEX75737 7