Other Certification
Table Of Contents
- 40270-308-05_eng
- 40270-308-05_spa
- H1G-S Generic Topic 1st Level - Introducción
- PBB-S Begin Safety Statements Bulleted List - • Utilice equipo de protección personal (EPP) apropiado y siga las prácticas de seguridad en trabajos eléctricos establecidas por su Compañía, consulte la norma 70E de NFPA o Z462 de CSA y NOM-029-...
- H2G-S Generic Topic 2nd Level - Construcción de barras de dos hileras
- H2G-S Generic Topic 2nd Level - Construcción de barras de una hilera
- H2G-S Generic Topic 2nd Level - Retire las placas removibles de la cubierta
- H1G-S Generic Topic 1st Level - Preparación para la instalación
- NB-S Begin Numbered List - 1. Retire los discos removibles. Según el diseño de discos removibles, utilice un destornillador para hacer palanca y extraer los discos exteriores uno por uno hasta obtener la abertura necesaria.
- H2G-S Generic Topic 2nd Level - Cómo instalar un interruptor automático
- NB-S Begin Numbered List - 1. Desenergice (O/OFF) el interruptor automático.
- NC-S Continue Numbered List - 2. Inserte el extremo con terminal del interruptor automático en el gancho de montaje.
- NC-S Continue Numbered List - 3. Empuje el interruptor hacia dentro hasta que las mordazas enchufables encajen firmemente sobre el conector de barra.
- NC-S Continue Numbered List - 4. Instale los conductores.
- NB-S Begin Numbered List - 1. Desenergice (O/OFF) el interruptor automático.
- H2G-S Generic Topic 2nd Level - Identificación de los circuitos
- H2G-S Generic Topic 2nd Level - Cómo energizar el circuito
- H2G-S Generic Topic 2nd Level - Cómo desmontar un interruptor automático
- H1G-S Generic Topic 1st Level - Introducción
40270-308-05 Circuit Breaker Installation for Homeline
TM
Combination Service Entrance Devices
Rev. 02, 04/2018 Instruction Bulletin
4
ENGLISH
Remove Cover Twistouts
• Remove only those twistouts which match installed circuit breakers by
twisting out with pliers at the center of twistout.
• Close unused circuit breaker openings with filler plates.
• Order catalog number HOMFP for filler plates. Each filler plate closes
one-pole branch circuit breaker opening.
Figure 7: Remove Cover Twistouts
Prepare for Installation
1. Remove knockouts. Appropriate to knockout pattern, drive center
knockout inward or outward. Alternately pry up or drive in outer rings one
at a time to opening required.
Figure 8: Remove Knockouts
2. Select the proper cable clamp, or use other approved methods for
securing the cable or conduit to the enclosure.
3. Install and wire branch circuit breakers.