Installation Guide

Schneider Electric USA

1601 Mercer Road

Lexington, KY 40511 USA

1-888-SquareD (1-888-778-2733)

www.us.SquareD.com

CTL Load Centers 40266-122-02

Instruction Bulletin 05/2005

Electrical equipment should be installed, operated, serviced, and

maintained only by qualified personnel. No responsibility is assumed

by Schneider Electric for any consequences arising out of the use of

this material.

Removal of Twistouts

1. Remove only those twistouts to match circuit breakers by twisting

out with pliers at center of twistout.

NOTE: Remove only one side when installing Q1 circuit breakers.

2. Close all unused open spaces in trim by ordering one of the

following filler plates:

— Catalog No. QOFP for spaces measuring 0.75 x 2.31 inches.

— Catalog No. QO1FP for spaces measuring 0.75 x 2.44 inches.

3. Remove only the twistouts necessary to match circuit breakers, by

rapping sharply with screwdriver at extreme corner away from tie.

4. For 2- and 3-pole circuit breakers, remove divider between

twistouts with pliers.

NOTE: Remove only one side when using Q1 circuit breakers.

5. Close all unused open spaces in trim by ordering filler plate

Catalog No. QOFP.

40266-122-02.fm Page 4 Tuesday, May 24, 2005 2:19 PM