Instructions / Assembly

METER–PAK™ Wireway 73298-753-01

Safety Precautions 12/01

Square D Company

1601 Mercer Road

Lexington, KY 40511 USA

1-888-SquareD (1-888-778-2733)

www.SquareD.com

Electrical equipment should be serviced only by qualified personnel. No responsibility is assumed

by Schneider Electric for any consequences arising out of the use of this material. This document

is not intended as an instruction manual for untrained persons.

SAFETY PRECAUTIONS

Before mounting the wireway, mount the MP METER–PAK meter center to

meet the utility minimum and maximum meter height measurements.

To mount the wireway to the meter center, see Figure 2.

Figure 2: METER–PAK Wireway Installation

HAZARD OF ELECTRIC SHOCK, BURN, OR EXPLOSION

• This kit must be installed and serviced only by qualified electrical personnel.

• Turn off all power supplying the equipment where this kit will be installed

before working on or inside the equipment.

• Always use a properly rated voltage sensing device to confirm that all

power is off.

• Replace all devices, doors, and covers after installing this kit and before

turning on power to the equipment.

Failure to follow these instructions will result in death or serious injury.

DANGER

MOUNTING WIREWAY

METER–PAK

Torque to 75 lb-in (9 N•m), four places)

4141-9621