Brochure
Table Of Contents
- Wireway Offerings
- Application and General Information
- General Purpose—NEMA Type 1 Painted Wireway
- Application
- Construction
- Finish
- Industry Standards
- Accessories
- Oiltight—NEMA Type 12 Wireway
- Application
- Construction
- Finish
- Industry Standards
- Accessories
- Raintight—NEMA Type 3R Wireway
- Application
- Construction
- Finish
- Industry Standards
- Raintight—NEMA Type 3R Trough
- Application
- Construction
- Finish
- Industry Standards
- Accessories
Square-Duct™ Wireways
Raintight—NEMA Type 3R Wireway
© 1986—2011 Schneider Electric
All Rights Reserved
26
08/2011
™
Straight Section 90° Flush Tee 30° Sweep Elbow
Available in lengths from 1 ft (30 cm) to 10 ft (305 cm).
Use wherever flush mounting
against a vertical surface is required.
When a large radius is needed, use this sweep elbow.
90° Elbow-Tee-Cross 90° Elbow Panel Adapter
Use when there are four branches. It can be
used as a 90° Elbow or a 90° Flush Tee
by adding Closure Plates.
Used whenever a right-angle installation
is needed.
Allows the wireway to be securely connected to an enclosure.
Closing Plate Reducer Connector
Closes the end of a wireway section or run. Used to reduce to a smaller wireway size. Used to rigidly join fittings to straight sections.
Drop Hanger Bracket Hanger Wall Hanger
Used to support a wireway run. Used to support a wireway run. Used to support a wireway run.
30 ˚
1.28 in.
(33 mm)
3.54 in.
(90 mm)
2.40 in.
(61 mm)