Brochure

Square-Duct™ Wireways
Oiltight—NEMA Type 12 Wireway
© 1986—2011 Schneider Electric
All Rights Reserved
20
08/2011
™
Box Connector Closing Plate Clockwise Transposition Section
When wireway enters an enclosure, a
box connector should be used on
the inside of the enclosure to ensure a tight seal.
Used to seal the end of a wireway
section or run.
These fittings are used when it is necessary to rotate the
open side of the wireway run by 90 ° and still retain the
lay-in feature.
Counter-Clockwise Transposition Section 90° Elbow Clockwise Transposition 90° Elbow Counter-Clockwise Transposition
These fittings are used when it is necessary to rotate the open side of the wireway run by 90° and still retain the lay-in feature.
Barrier, Bracket Mounted Barrier Kit (Bolt-On)
Divides wireway into two or three compartments. Spring steel brackets hold barriers
in place by friction fit inside wireway. Order barrier and bracket separately.
Recommended spacing in increments of 3 ft (91 cm).
W = 3.00 in. (76 mm) for 4.00 in. x 4.00 in. (102 mm x 102 mm)
W = 4.50 in. (114 mm) for 6.00 in. x 6.00 in. (152 mm x 152 mm)
Divides wireway into two or more compartments. Barriers
are fastened to wireway sections with screws. Sealing
washers are included.
W = 3.00 in. (76 mm) for 4.00 in. x 4.00 in.
(102 mm x 102 mm)
W = 4.50 in. (114 mm) for 6.00 in. x 6.00 in.
(152 mm x 152 mm)
W = 6.00 in. (152 mm) for 8.00 in. x 8.00 in.
(203 mm x 203 mm)
12.00 in.
(305 mm)
12.00 in.
(305 mm)
Bracket
2 compartment
Barrier
Barriers
Bracket
3 compartment
5.00 ft
(152 cm)
5.00 ft
(152 cm)
5.00 ft
(152 cm)
.62 in.
(16 mm)
.97 in.
(25 mm)
.25 in.
(6 mm)