Brochure
Table Of Contents
- Wireway Offerings
- Application and General Information
- General Purpose—NEMA Type 1 Painted Wireway
- Application
- Construction
- Finish
- Industry Standards
- Accessories
- Oiltight—NEMA Type 12 Wireway
- Application
- Construction
- Finish
- Industry Standards
- Accessories
- Raintight—NEMA Type 3R Wireway
- Application
- Construction
- Finish
- Industry Standards
- Raintight—NEMA Type 3R Trough
- Application
- Construction
- Finish
- Industry Standards
- Accessories
Square-Duct™ Wireways
Oiltight—NEMA Type 12 Wireway
19
08/2011
© 1986—2011 Schneider Electric
All Rights Reserved
™
90° Elbow Outside Top Opening 45° Elbow Top Opening 45° Elbow Inside Opening
This elbow fitting allows a vertical drop to equipment
below at a 90° corner while maintaining the
top opening lay-in feature.
Similar to the 90° elbows in design and function, but is used where a 45° angle is needed.
45° Elbow Outside Opening Tee Top Opening Outside Tee Top Opening
Similar to the 90° elbows in design and function,
but is used where a 45° angle is needed.
This fitting is used when the covers of all three
branches of the wireway run are open along the
same side.
This fitting is used when the covers of two branches are on
the same side and the third cover is on a different side.
Nipple Drop Hanger Bracket Hanger
Available in lengths of 1.00 in. (25 mm), 2.00 in.
(51 mm), 3.00 in. (76 mm), and 6.00 in. (152 mm).
Hangers are used to support a wireway run. The drop hanger is normally attached to an overhead beam or
ceiling, while the bracket hanger can be used for wall, floor, or ceiling installations.