Brochure

18-48
© 2019 Schneider Electric
All Rights Reserved
Motor Starters and Protectors TeSys™ D Enclosed Combination Starters
www.se.com/us
Refer to Catalog MKTED210011EN
Table 18.161: Factory Modifications for Control Circuit Transformers
Symbol Description VA For Starter Assembly by NEMA Type 1 and 12
Suffix/Cat. No. [69]
Full voltage starters
(Standard VA capacity)
50 LE1, LE2, LES, LER Factory A206P
D09 - D32 Field Installation LA9TFD32●[70]
100 D40 - D80 Factory A206P
Field Installation LA9TFD80●[70]
150 D115 - D150 Factory A206P
Field Installation LA9TFD15●[70]
Full voltage starters
+ 50 VA extra capacity
— D09 - D80 Factory A207P
D11 - D15 Factory A207P
Full voltage starters, special primary or
secondary voltage
— D09 - D80 Factory A209P
D11 - D15 Factory A209P
Table 18.162: Voltage Codes for Control Power Transformers
Primary
Voltage
120 208 240 480 600 208 240 480 600
Secondary
Voltage
24 V 120 V
Code E D C B A L M T X
Factory Modifications and Insta-Kits Selection for Control Circuits
and Meters
Table 18.163: Factory Modifications for Control Circuits
Symbol Description
For Starter
Assembly by
NEMA Type 1 and 12
Suffix/Cat. No. [71]
Auxiliary contact block
(terminals and wiring
not included)
2 contacts
All listed
Factory
A200
Field Installation LADN11
4 contacts
Factory
A400
Field Installation LADN22
Auxiliary contact blocks
on disconnect
NO or NC
wired
Factory
A101
NO or NC
unwired
Factory
A102
Auxiliary contact blocks
on instantaneous trip
circuit interrupter
NO or NC
wired
Factory
A103
Fuses for control circuit
(terminals not included)
2 x 600 V fuses
Factory
A104
1 x 250 V fuse
Factory
A105
2 x 250 V fuse
Factory
A106
Control circuit relay
4 poles unwired Factory
A111
4 poles unwired (coil and 1 contact
wired; terminals not included)
Factory
A112
Time delay relay
Unwired
Factory
A113
Wired (coil and 1 contact wired;
terminals not included)
Factory
A114
Thermistor control relay, LT3
c/w 10 terminals max
—
Factory
A115
18
CONTACTORS AND STARTERS-IEC
[69] Catalog numbers beginning with LA9 are only for starters with a “2” before the voltage code. When using a factory option that does not have a corresponding customer kit, the 10th digit of
the starter must change from a "2" to a "1".
[70] Replace (●) with the corresponding suffix from Table 18.162.
[71] Catalog numbers beginning with LA9 are only for starters with a “2” before the voltage code.
9/13/2019