Brochure

18-46
© 2019 Schneider Electric
All Rights Reserved
Motor Starters and Protectors TeSys™ D Enclosed Combination Starters
www.se.com/us
Refer to Catalog MKTED210011EN
Factory Modifications and Insta-Kits Selection
Add the factory modification code to the end of the catalog number created from page
18-42. With the use of Insta-Kits, only one operator scheme is allowed. Only the
combinations of operators and pilot lights shown below can be ordered.
Pilot lights will be at the coil voltage indicated in the catalog number for the starter.
L1 L2
PL
M
OFF ON
1 2 3 4 A B
OLR
95 96
X1 X2
PL
61 62 X1 X2
L1 L2
M
HAND AUTO
OFF
PL
X1 X2
3 4
3 4
95 96
61 62
PL
X1 X2
Remote by Customer Connection
L1 L2
START
STOP
1 2
A B
3 4
M
95 96
13 14
OLR
From top to bottom: Start/Stop, On - Off Selector Switch, HOA
Selector Switch
L1 L2 L3
M
98
97
B
A
96
95
13
14
T1 T2 T3
D-Line AC Magnetic Starter, 2–3 Pole
L1 L2 L3
21
22
+
+
B
A
B
A
F
R
T1 T2 T3
21
22
+
+
97
98
96
95
"C"
D-Line AC Magnetic Reversing Starter, 3–Pole
Table 18.157: Factory Modifications for One Operator on Cover
Symbol Description Color Nameplate Assembly by Suffix/Cat. No. [64]
NEMA Type 1 NEMA Type 12
One operator on cover
Push button, mushroom, 40 mm
Red
Emergency
Stop
Factory
A06A A07A
Push button (double touch)
Black
Red
I / O
Factory
A06I A07I
Field Installation LA9CA06IO LA9CA06IO
2 Position selector switch Black Off - On
Factory
A06D A07D
Field Installation LA9CA06DT LA9CA06DT
3 Position selector switch Black Hand - Off - Auto
Factory
A06E A07E
Field Installation LA9CA06ET LA9CA06ET
Pilot light (direct)
Green Power On
Factory
A06S A07S
Field Installation LA9CA06ST LA9CA06ST
Pilot light (transformer type)
Green Power On
Factory
A06F A07F
Field Installation
LA9CA06FT●[65] LA9CA06FT●[65]
Pilot light (LED type)
Green Power On
Factory
A16S A17S
Field Installation
LA9CA16ST●[65] LA9CA16ST●[65]
18
CONTACTORS AND STARTERS-IEC
[64] Catalog numbers beginning with LA9 are only for starters with a “2” before the voltage code. When using a factory option that does not have a corresponding customer kit, the 10th digit of
the starter must change from a "2" to a "1".
[65] Replace (●) with coil voltage code corresponding to the pilot light voltage in Table 18.160.
9/13/2019