Brochure

18-26
© 2019 Schneider Electric
All Rights Reserved
Motor Starters and Protectors TeSys™ U Enclosed Combination Starters
www.se.com/us
Refer to Catalog MKTED210011EN
1. Choose a base configuration
Table 18.100: Base Configurations
Ratings Type 1/12/3R enclosure Type 4/4X enclosure
Motor Voltage (V)
Max. HP
Max. Current (A)
Non-reversing
starter
Reversing starter
Non-reversing
starter
Reversing starter
Single phase Three-phase
Base Configuration
Number
Base Configuration
Number
Base Configuration
Number
Base Configuration
Number
115 1.5
12 LE1U16 LE2U16 LE1U19 LE2U19
230 2
200 3
230 3
460 7.5
575 10
115 2
32 LE1U36 LE2U36 LE1U39 LE2U39
230 5
200 10
230 10
460 20
575 25
Type 1/12/3R enclosure Type 4/4X enclosure
2. Choose Thermal Overload Relay (Plug-in Control Unit)
The thermal overload relay is a control unit that plugs into the TeSys U starter. No tool is
needed to install or remove the control unit.
If you do not wish to select the thermal overload relay at this time, select Thermal
Overload Relay Type codes N1 or N3 in function of the motor configuration (single phase
or 3–phase) in . A thermal overload relay can be selected and ordered later on
(independently) before installation.
In order to select a thermal overload relay, you must follow the next 2 steps. First, select
the thermal overload protection type code in . Secondly, select the full load amperage
code in .
18
CONTACTORS AND STARTERS-IEC
9/13/2019