Specification
Homeline
®
Circuit Breakers and Load Centers—Class 1170
General Information and Application Data
43
03/2007
© 2007 Schneider Electric All Rights Reserved
Indoor Enclosures (NEMA Type 1)
Welded sheet steel with knockouts at top, bottom, back and sides
Finish: gray baked enamel electrodeposited over cleaned, phosphatized
steel
Most indoor enclosures are 14.25 in (362 mm) wide
Top or bottom feed by rotating enclosure
Indoor Covers
Doors to cover circuit breaker handles, except on 24 , 48 and 61 2
circuit models
Combination flush and surface cover with latch opening door included
with load centers
Automatic flush adjustment is standard
Triple lead cover screws for fast cover installation
Shutter-type twistouts
HOMFP snap-in style filler plates available for all covers
QOM1FP filler plates available for 10012 5 A convertible load center
covers
QOM2FP filler plates available for 15022 5 A convertible load center
covers
Rainproof Enclosures (NEMA Type 3R)
Complete enclosure includes interior trim and door
Welded galvannealed steel
Finish: gray baked enamel electrodeposited over cleaned,
phosphatized, galvannealed steel
RB devices have provisions for interchangeable bolt-on hub
Top centered rainproof mounting boss on the back of the enclosure
simplifies installation and saves time
Stainless steel door latch on the enclosure provides a secure closure
and maximum durability
Convertible main panels are side-hinge door devices
Side-hinged door provides full wiring access without door removal
Allow 1.25 in (32 mm) on the left side for the door to open
Bolt-On Hubs
Hubs available for 0.75 in (19 mm) to 4 in (102 mm) conduit size (see
page 46)
No gasket required with hubs from 0.75 in (19 mm) to 2.50 in (64 mm)
when used on RB type load centers
HOM40M200C With Cover
New RB Device
Bolt-On Hubs