Buying Guide

2 I Plug-on Neutral Load Centers with Qwik-Grip Wire Management System
Square D Plug-on Neutral Load Centers with
Qwik-Grip wire management system speeds
up wire installation simplifying your rough-in.
QO and Homeline
Load Centers with Qwik-Grip:
Electrical contractors will appreciate not having to
remove knockouts, install wire connectors and
blindly pull wire into the load center versus the
ability to slide wires from the front with the
Qwik-Grip wire management system. A quick
bend of the wire using the wire bend guide
on the Qwik-Grip insert and the wire easily
slides into the slot. Once done, snap on the
Qwik-Grip shield to keep the wires behind
the router for a secure, code compliant
installation. Qwik-Grip, a state of the art wire
management system, allowing you to move
on the next job quicker.
Eliminate the need for half-inch and most three-quarter
inch knockouts and box connectors with Qwik-Grip.
Qwik-Grip inserts are factory installed and ready to wire. Simply snap off a
Qwiklet tab, and slide in the wire. If too many tabs are removed, an ample
supply of fillers are included. Wires slide into the Qwik-Grip module with each
slot holding 3 to 5 NM-B wires, then wires are locked into place using the
Qwik-Grip shield. This is the easiest and fastest way to install a Load Center in
the marketplace today.
Qwik-Grip Wire Management System
• Eliminates most knockout removal
• Eliminates most box connectors
• Speeds up and simplifies rough-ins
• Great for service up-grades, remodels or just adding a circuit
• UL Listed, code compliant