Installation Guide
Table Of Contents
- 40270-308-05_eng
- 40270-308-05_spa
- H1G-S Generic Topic 1st Level - Introducción
- PBB-S Begin Safety Statements Bulleted List - • Utilice equipo de protección personal (EPP) apropiado y siga las prácticas de seguridad en trabajos eléctricos establecidas por su Compañía, consulte la norma 70E de NFPA o Z462 de CSA y NOM-029-...
- H2G-S Generic Topic 2nd Level - Construcción de barras de dos hileras
- H2G-S Generic Topic 2nd Level - Construcción de barras de una hilera
- H2G-S Generic Topic 2nd Level - Retire las placas removibles de la cubierta
- H1G-S Generic Topic 1st Level - Preparación para la instalación
- NB-S Begin Numbered List - 1. Retire los discos removibles. Según el diseño de discos removibles, utilice un destornillador para hacer palanca y extraer los discos exteriores uno por uno hasta obtener la abertura necesaria.
- H2G-S Generic Topic 2nd Level - Cómo instalar un interruptor automático
- NB-S Begin Numbered List - 1. Desenergice (O/OFF) el interruptor automático.
- NC-S Continue Numbered List - 2. Inserte el extremo con terminal del interruptor automático en el gancho de montaje.
- NC-S Continue Numbered List - 3. Empuje el interruptor hacia dentro hasta que las mordazas enchufables encajen firmemente sobre el conector de barra.
- NC-S Continue Numbered List - 4. Instale los conductores.
- NB-S Begin Numbered List - 1. Desenergice (O/OFF) el interruptor automático.
- H2G-S Generic Topic 2nd Level - Identificación de los circuitos
- H2G-S Generic Topic 2nd Level - Cómo energizar el circuito
- H2G-S Generic Topic 2nd Level - Cómo desmontar un interruptor automático
- H1G-S Generic Topic 1st Level - Introducción
Schneider Electric USA, Inc.
800 Federal Street
Andover, MA 01810 USA
1-888-778-2733
www.schneider-electric.us
Circuit Breaker Installation for Homeline
TM
Combination Service Entrance Devices 40270-308-05
Instruction Bulletin Rev. 02, 04/2018
Electrical equipment should be installed, operated, serviced, and
maintained only by qualified personnel. No responsibility is assumed
by Schneider Electric for any consequences arising out of the use of
this material.
Schneider Electric and Square D are trademarks owned by
Schneider Electric Industries SAS or its affiliated companies. All
other trademarks are the property of their respective owners.
6
ENGLISH
© 2006–2018 Schneider Electric All Rights Reserved
Removal of Circuit Breakers
1. Turn circuit breakers OFF.
2. Remove wires.
3. Disconnect plug-on jaws from bus bar connection by pulling circuit
breaker outward until it disengages from mounting hook.