Instructions / Assembly

Circuit Breaker Installation for Homeline
TM
Combination Service Entrance Devices 40270-308-05
Instruction Bulletin Rev. 02, 04/2018
5
ENGLISH
Circuit Breaker Installation
1. Turn off circuit breaker.
2. Insert wire terminal end of circuit breaker into mounting hook.
3. Push circuit breaker inward until plug-on jaws plug securely on to bus bar
connector.
4. Install wires.
Identify Circuits
Identify branch circuits on directory label or directory stickers.
Energize the Circuit
Note: Before energizing combination service entrance devices, turn main and
branch circuit breakers to the OFF position.
1. Turned on power to the combination service entrance device.
2. Turn main circuit breaker ON.
3. Turn on branch circuit breakers.
Handle at mid position indicates the circuit breaker is tripped. To reset, move
handle to the off position and then to the on position.
Figure 9: Energize the Circuit
CAUTION
HAZARD OF EQUIPMENT DAMAGE
Use only Homeline
TM
circuit breakers and replacement parts with this
product. Use of other components voids the warranty, may void the UL
listing and may result in personal injury or equipment damage. Refer to
device markings for specific restrictions.
Failure to follow this instruction can result in personal injury or
equipment damage.
ON
OFF
ON
OFF
11003019
ON
OFF
Tripped