Installation Guide
30 A General Duty Safety Switches 40269-522-03
Interruptores de seguridad de uso general de 30 A Rev. 01, 05/2011
Electrical equipment should be installed, operated, serviced, and
maintained only by qualified personnel. No responsibility is assumed
by Schneider Electric for any consequences arising out of the use of
this material.
Solamente el personal especializado deberá instalar, hacer funcionar y prestar servicios
de mantenimiento al equipo eléctrico. Schneider Electric no asume responsabilidad
alguna por las consecuencias emergentes de la utilización de este material.
Square D
™
and Schneider Electric™
are trademarks or registered
trademarks of Schneider Electric. Other trademarks used herein are
the property of their respective owners.
Square D™ y Schneider Electric™ son marcas comerciales o marcas registradas de
Schneider Electric. Cualquier otra marca comercial utilizada en este documento
pertenece a sus respectivos propietarios.
Schneider Electric USA, Inc.
1601 Mercer Road
Lexington, KY 40511 USA
1-888-SquareD (1-888-778-2733)
www.schneider-electric.us
Importado en México por:
Schneider Electric México, S.A. de C.V.
Calz. J. Rojo Gómez 1121-A
Col. Gpe. del Moral 09300 México, D.F.
Tel. 55-5804-5000
www.schneider-electric.com.mx
© 2011 Schneider Electric All Rights Reserved / Reservados todos los derechos
4
Energizing the Switch Cómo energizar el interruptor
1. Close the cover. 1. Cierre la cubierta.
2. Turn OFF (O) the switch. 2. Desconecte (O/OFF) el interruptor.
3. Turn OFF (O) all of the downstream loads. 3. Desconecte (O/OFF) todas las cargas del lado de la carga.
4. Turn ON (I) the power to the equipment in
sequence; start at the source end of the system and
work toward the load end.
4. Energice (I/ON) el equipo en secuencia; comience por el extremo
de la fuente del sistema y proceda hasta el extremo de la carga.