User Guide
Table Of Contents
- Altivar Machine ATV320
- Table of Contents
- Safety Information
- About the Book
- Introduction to Device Conversion Function
- Control Block Terminals
- Functions Compatibilities
- Applicative Functions
- Reverse
- Reverse Inhibition
- Speed Loop Parameters
- Macro-Configurations
- I/O Multi-Assignments
- 2/3 Wires Control
- Freewheel Stop
- Fast Stop
- Ramp Types
- Ramp Switching
- Ramp Auto-Adaptation
- DC Injection Braking
- Reference Switching
- Separate Mode (Command & Reference)
- Reference Operation
- Jog
- Preset Speeds
- Brake Control Sequence
- +/- Speed
- 2nd Current Limitation
- Jump Frequency
- PID Regulator
- Internal PID reference
- Preset PID Reference
- Sleep / Wake-Up
- Catch On the Fly
- Automatic Restart
- Multi-Motors / Multi-Configurations
QGH39563 02/2017 7
Damaged products or accessories may cause electric shock or unanticipated equipment operation.
Contact your local Schneider Electric sales office if you detect any damage whatsoever.
(1) For USA: Additional information, refer to NEMA ICS 1.1 (latest edition), Safety Guidelines for the
Application, Installation, and Maintenance of Solid State Control and to NEMA ICS 7.1 (latest edition),
Safety Standards for Construction and Guide for Selection, Installation and Operation of Adjustable-Speed
Drive Systems.
The temperature of the products described in this manual may exceed 80 °C (176 °F) during operation.
This equipment has been designed to operate outside of any hazardous location. Only install this
equipment in zones known to be free of a hazardous atmosphere.
DANGER
ELECTRIC SHOCK OR UNANTICIPATED EQUIPMENT OPERATION
Do not use damaged products or accessories.
Failure to follow these instructions will result in death or serious injury.
WARNING
LOSS OF CONTROL
The designer of any control scheme must consider the potential failure modes of control paths and,
for critical control functions, provide a means to achieve a safe state during and after a path failure.
Examples of critical control functions are emergency stop, overtravel stop, power outage and restart.
Separate or redundant control paths must be provided for critical control functions.
System control paths may include communication links. Consideration must be given to the
implications of unanticipated transmission delays or failures of the link.
Observe all accident prevention regulations and local safety guidelines (1).
Each implementation of the product must be individually and thoroughly tested for proper operation
before being placed into service.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
NOTICE
DESTRUCTION DUE TO INCORRECT MAINS VOLTAGE
Before switching on and configuring the product, verify that it is approved for the mains voltage
Failure to follow these instructions can result in equipment damage.
WARNING
HOT SURFACES
Ensure that any contact with hot surfaces is avoided.
Do not allow flammable or heat-sensitive parts in the immediate vicinity of hot surfaces.
Verify that the product has sufficiently cooled down before handling it.
Verify that the heat dissipation is sufficient by performing a test run under maximum load conditions.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
DANGER
POTENTIAL FOR EXPLOSION
Install and use this equipment in non-hazardous locations only.
Failure to follow these instructions will result in death or serious injury.