User Guide
Table Of Contents
- Altivar Machine ATV320
- Table of Contents
- Safety Information
- About the Book
- Introduction to Device Conversion Function
- Control Block Terminals
- Functions Compatibilities
- Applicative Functions
- Reverse
- Reverse Inhibition
- Speed Loop Parameters
- Macro-Configurations
- I/O Multi-Assignments
- 2/3 Wires Control
- Freewheel Stop
- Fast Stop
- Ramp Types
- Ramp Switching
- Ramp Auto-Adaptation
- DC Injection Braking
- Reference Switching
- Separate Mode (Command & Reference)
- Reference Operation
- Jog
- Preset Speeds
- Brake Control Sequence
- +/- Speed
- 2nd Current Limitation
- Jump Frequency
- PID Regulator
- Internal PID reference
- Preset PID Reference
- Sleep / Wake-Up
- Catch On the Fly
- Automatic Restart
- Multi-Motors / Multi-Configurations
QGH39563 02/2017 5
Safety Information
Important Information
NOTICE
Read these instructions carefully, and look at the equipment to become familiar with the device before
trying to install, operate, service, or maintain it. The following special messages may appear throughout
this documentation or on the equipment to warn of potential hazards or to call attention to information that
clarifies or simplifies a procedure.
PLEASE NOTE
Electrical equipment should be installed, operated, serviced, and maintained only by qualified personnel.
No responsibility is assumed by Schneider Electric for any consequences arising out of the use of this
material.
A qualified person is one who has skills and knowledge related to the construction and operation of
electrical equipment and its installation, and has received safety training to recognize and avoid the
hazards involved.
Qualification Of Personnel
Only appropriately trained persons who are familiar with and understand the contents of this manual and
all other pertinent product documentation are authorized to work on and with this product. In addition, these
persons must have received safety training to recognize and avoid hazards involved. These persons must
have sufficient technical training, knowledge and experience and be able to foresee and detect potential
hazards that may be caused by using the product, by changing the settings and by the mechanical,
electrical and electronic equipment of the entire system in which the product is used. All persons working
on and with the product must be fully familiar with all applicable standards, directives, and accident
prevention regulations when performing such work.